Samsung Galaxy S8 & S8 Plus Official Stock Roms/ Firmware with Odin Flash Tool

370

Samsung Galaxy S8 and S8 Plus

If you are searching and tensed about, how to install stock firmware on your Samsung Galaxy S8 and S8 Plus users. Here we will guide you how to install it on your device without any issue. As you all know that Samsung has released its flagship devices Samsung Galaxy S8 and S8 Plus in 2017. These devices may come on Android 7.0 Nougat out of the box.

This device packs with a 1440x2960pixels Super AMOLED Display and it sports a 12MP rear camera. On the front, It bears an 8MP selfie camera. It has a Qualcomm Snapdragon 835 Chipset and packs a 3000/3500mAh of the battery.

The main highlight feature of the Samsung devices was its stock firmware performance. If your device was hard bricked or soft bricked or may in a dead state then this ODIN software may help you to solve this problem and the device may boot in the stock firmware.By using this ODIN software you can flash, Boot your device. Here in this article, we are providing the simple steps to use the ODIN software.

If you are installing custom ROMs by rooting your device, then you may get some errors like a Hard brick, soft brick or some time its may dead, Then you can simply by following this guide you can able to solve the errors and can Install the Stock Firmware on your device.

Pre-Requirements:

Obtain Minimum of 50-60% of Charging on your device

Keep in mind that this is only for S8 and S8 Plus users

Install the Samsung Galaxy S8/S8 Plus USB Drivers on your PC

Steps To Install:

First Install the ODIN Flash tool by downloading from the below link

Check and download the correct firmware for your device

Enable the USB debugging mode on your device by simply doing this steps Settings->About Phone->Tap 6-7 times on Build Number.

Now by going back to Main Menu-> Developer, enable the OEM unlocking

Boot your device into Download Mode by holding Bixby Button+Power+Volume Up buttons

Now open the ODIN Flash tool on your PC and run it as Administrator

Connect your device to PC via USB cable

The device when connected, the id.com turns into blue colour

Now tick the AP button and add the firmware.tar or .md5 file

Next, go to options tab and uncheck the Auto-Reboot box

Then click on START to start the installation process

After it’s finished the process, you may get PASS pop-up message

Now Disconnect your device from your PC

That’s All.

Files to Download:

Samsung Galaxy S8 Stock firmware

Samsung Galaxy S8 Plus Stock Firmware

ODIN Tool

You might also like More from author

Comments